Is the high-pressure industrial washing machine the better the pressure?
A high-pressure industrial washing machine with a hollow shaft motor does not have a greater pressure. The better the effect? No, generally we think that the cleaning is not clean enough pressure. In fact, it is necessary to analyze the specific problems, such as cleaning oil, especially sticky oil, relying on Pressure is useless. If you use a large pressure to rinse, it will only make the oil and the surface of the surface to be cleaned more firmly. It needs to be dissolved at a high temperature to make it easier to clean. Some customers will say that I add some strong acid and alkali to clean the weight. Oil stains, in fact, the high corrosivity of strong acid and alkali, whether it is high-pressure pump and seals of high-pressure cleaners or the surface to be cleaned is very destructive, long-term use of strong acid and alkali will accelerate the aging of equipment so that the failure rate is improved， greatly shortening the service life of the equipment. Therefore, the pressure washer is not the bigger, the better, the choice of the right equipment is significant!
The working principle of the high-pressure cleaner is that the piston pump moves through a fixed seal, and a piston moves back and forth. The piston pump reciprocates by the piston so that the working volume of the pump chamber changes periodically, and the liquid is sucked and discharged. The plunger pump seal is mounted on the plunger through a smooth cylinder wall. It mainly uses the plunger to reciprocate in the pump cylinder... The piston pump moves through a fixed seal, and a piston moves back and forth. The piston pump reciprocates by the piston so that the working volume of the pump chamber changes periodically, and the liquid is sucked and discharged. The plunger pump seal is mounted on the plunger through a smooth cylinder wall. It mainly uses a plunger to reciprocate in the pump cylinder to form a volume change between the plunger and the pump wall, repeatedly pumping and discharging the liquid and increasing the pump's pressure. Plunger pumps generally have better initial use characteristics. They have the advantages of high rated pressure, compact structure, high-efficiency ，, and convenient flow adjustment. Still, their disadvantages are that they cannot operate under excessive pressure and have a short service life.
What is the high-pressure cleaner for cutting metal? The cutting metal is generally an ultra-high pressure cleaner. It is different from the general high-pressure cleaner. The pressure of the water can be up to 500 kg. The high-pressure nozzle is made of special materials. Very hard and wear-resistant, the nozzle is a skinny hole because the pressure is 500 kg, so the high-pressure water jet sprayed has an extreme penetrating power, can cut metal and non-metal materials, and even cut reinforced concrete material. This is a good choice for the cutting industry! Not only that, but the ultra-high pressure cleaner can also punch holes in these materials, greatly improving the cutting effect and quality.
Precautions before the use of steam high-pressure cleaners? If mechanical equipment is used for a long time, it should not be neglected in normal maintenance. The high-pressure cleaning machine is no exception. The daily maintenance work mainly includes 1. Check whether the inlet and outlet pipes are folded before work and the damaged image。 2. Check the smooth oil level on the crankcase and replace it once every three months. 3, the water inlet filter should always check for blockage. Clean the filter once a week. 4. Wash and wash the high-pressure oil pump for three months.
Fuan Zhongzhi Pump Co., Ltd
registered the trademark "ZOZHI."
Add:No.155 Shangcun Qinxiyang Industry Zone,Fuan city,Fujian,China
Tel:+86 0593 6532656 Fax: +86 0593 6531158
Mobile: +86.137.0604.0131
E-mail: sales@zz-pump.com
Website: www.zz-pump.com