The working medium of an ultra high-pressure washer is the same as another high-pressure washer. The working medium is pure water.
The working medium of an ultra-high pressure washer with a hollow shaft motor is the same as another high-pressure washer. The working medium is pure water. After the ordinary tap water is pressurized to more than one thousand atmospheric pressure by a high-pressure water pump, a high-concentration energy jet is ejected through a high-pressure nozzle with a small aperture bundle.
The economic benefits brought by the high-pressure cleaner to the sucrose industry. The application of high-pressure cleaners in the sucrose plant is becoming more and more widespread. It is an essential workflow for the sucrose industry to wash the tank. The entire pressing season requires almost 90 tanks. The traditional tank washing method requires about 200kg of alkali each time. A pressing season is almost 20,000KG, and the cost of light alkali is hundreds of thousands. Not only this, there are many labor costs. Now labor The rising wages are also a big expense. If you use a high-pressure cleaner for cleaning, the cost is much lower. Because no cleaning agent is added, the cleaning water can be recycled after filtering from workforce and resources, etc. It seems that the cost has been greatly saved, and the cost can be recovered in one season.
The high-pressure cleaner is the most important piece of equipment in the cleaning industry. After the ordinary tap water is pressurized to the pressure set by the machine through a high-pressure water pump, a highly concentrated water jet is ejected through a high-pressure nozzle with a small hole diameter. The water jet has huge pressure, and the instant release on the cleaned dirt can remove dirt on the equipment surface. The whole process has no medium except water, so it will not cause any pollution to the environment. Therefore, it is a well-deserved environmental protection cleaning equipment. So it is recognized by more and more people.
When using the steam pressure washer, you should connect the steam pressure washer to a stable and appropriate water level. Then, the water shortage lamp lights up, and the beep sounds to indicate that the water is full when added. At this time, you should stop the water, and the water is full. In addition, there will be a warning of water flowing out of the overflow pipe at the bottom of the machine. In short, maintain a proper water level. If you see that the water indicator of the high-pressure steam cleaner is off, turn on the start switch, the heating indicator is on, and enter the heating stage of the heat engine. After about 60 seconds, the pump indicator is on, and the pump starts to supply water and steam.
What kind of high-pressure water pipe is good for a high-pressure cleaning machine? The high-pressure water pipe of the high-pressure cleaning machine has always been a relatively large loss component, which has a great impact on the use cost of the machine, so you should pay attention to the maintenance of the high-pressure water pipe. However, if used and maintained properly, it can be used for a relatively long time to save and reduce costs.
registered the trademark "ZOZHI."
Add:No.155 Shangcun Qinxiyang Industry Zone,Fuan city,Fujian,China
Tel:+86 0593 6532656 Fax: +86 0593 6531158